• SCLK – Main clock synchronizing SPI on both devices. Generated by the Master to all the slaves
• MOSI – Master Output and Slave Input in which data is sent from the master to the slave on each clock edge
• MISO – Master Input and Slave Output in which data is sent from the slave to the master on each clock edge
• SS – Slave select, often called CS (Chip Select) or CSn. This line selects the current active slave. It could be Active Low or Active high (refer to the slave datasheet)

• CPHA/CKPH = 0, Read on the leading edge of each clock pulse. Written on the trailing edge of each clock pulse.
• CPHA/ CKPH = 1 , Written on the leading edge of each clock pulse. Read on the trailing edge of each clock pulse.
• CPOL/CKPL = 0 Clock idles low between transfers.
• CPOL/CKPL = 1 Clock idles High between transfers.

A combination of phase and polarity produces 4 standard modes for the clock in SPI:

It is important that the right phase and polarity are selected so that the slave and master both capture the bit at the correct clock transition.

• Select the Universal Serial Communication Interface (USCI) modules (USCI_A and USCI _B) or the universal Serial Interface (USI). Some devices have more than one USCI in which called USCI_A0, USCI_A1 and so on.
• Configure the 3 Pins (Clock, MOSI, SOMI) for SPI by configuring PxSEL0 and PxSEL1 to select the SPI function for those pins. (refer to the datasheet of your microcontroller to knew what value you should assign for each register).

Example using UCB0 module for MSp430Fr5969

P1SEL1 |= BIT6;  // P1.6-> UCB0SIMO
P1SEL1 |= BIT7 ; //P1.7-> UCB0SOMI
P2SEL1 |= BIT2 ; //P2.2-> UCB0CLK
* Set up the CS pin as output.
* Set up the Clock speed and mode that match the salve speed and mode. (refer to the slave’s datasheet)

• UART transmits bits sequentially by pulling the UART line low for a fixed amount of time determined by the baud rate. T
• The UART line when idle is high at the I/O level, 3.3V or whatever the VCC of the MSP430 is set.

• Refer to the datasheet to select the available module for UART.
• Configure the 2 Pins (tx and rx) for UART by configuring PxSEL0 and PxSEL1 to select the UART function for those pins. (refer to the datasheet of your microcontroller to knew what value you should assign for each register).

example using UCA0 module for MSP430FR5994

Config pins for UART operation P2.0 → UCA0TXD , P2.1→ UCA0RXD

P2SEL0 &= ~(BIT0 | BIT1);

P2SEL1 |= (BIT0 | BIT1);

• Set the baud rate.

Clock source 8 MHz and desired baud rate is 9600.

Step1: N = 8000000/9600 > 16

Step3: UCBRx = int (N/16) = 52 , OS16 = 1,

UCBRFx = int( ( (N/16) – INT(N/16) ) × 16) = 1

Step4: UCBRSx = 0x49 (by looking up the fractional part of N ( = N - INT(N) = 0.333333)